Equipment Education7

Used Agrify Vertical Farming Unit Checks

Buying a used Agrify vertical farming unit? Check Insights software access, chilled water, 8 foot chambers stacked 3 high and parts with no OEM backing.

Cured flower held beside a water activity analyzer
Cured flower held beside a water activity analyzer

Buy a used Agrify vertical farming unit only after you confirm three things: software access, a chilled water plant sized for every chamber, and ceiling height for stacking. Agrify's 2021 annual report says a VFU cannot operate successfully without Agrify Insights software, and that software went to a private buyer in December 2024. No factory warranty exists.

That makes a used VFU a different purchase from a used dehumidifier or light. You are buying hardware that was designed around one company's cloud software, from a market where that company no longer makes equipment.

What is an Agrify vertical farming unit?

An Agrify vertical farming unit is an enclosed grow chamber with its own lighting, airflow and climate control, built to stack in a warehouse. Agrify's 2021 annual report describes an 8 foot tall working area with two rows of plants, units that stack up to 3 high, and a water chilled fan coil holding temperature within 1.5°F.

The same Agrify 2021 annual report lists the rest of the build.

  • Enclosure: aluminum frame, antimicrobial plastics, motorized curtains on both sides of each grow area.
  • Electronics: rated IP65.
  • Lighting: LEDs with polycarbonate lenses, with interlighting that dims or turns off when the curtains are raised.
  • Sensors: values sampled every minute and reported to the cloud every 15 minutes, about 1.5 million data points per chamber per year.
  • Integration: units tie into a mezzanine catwalk system for access to upper tiers.
  • Target buildings: facilities of 20,000 to 50,000 square feet.

Agrify sold the VFU line, the total turnkey assets and Agrify Insights to CP Acquisitions, LLC on December 31, 2024. The full timeline for every Agrify brand is in our Agrify owner guide after the exit.

Can a used VFU run without Agrify Insights?

Agrify's own filing says no: the 2021 annual report states that the VFU cannot operate successfully without Agrify Insights software. Insights controlled temperature, humidity, VPD and CO2 inside each chamber and ran irrigation at the facility level, so losing it means losing the control layer, not just the dashboard.

In 2021 Agrify typically charged $2,400 to $3,600 per VFU per year for the software. The December 2024 sale announcement moved Insights to CP Acquisitions, LLC, an entity affiliated with former Agrify CEO Raymond Chang, and says nothing about licenses for existing customers.

  1. Ask the seller for the Insights account status and whether the license transfers with the chambers.
  2. Contact CP Acquisitions and get written confirmation that a license is available for these serial numbers.
  3. Ask to see the chambers running under live control, not idle.
  4. If no license is available, price a controls retrofit by a third party integrator before you make an offer.

We would not buy one without step 2 in writing. A retrofit is possible in principle, but it is an engineering project with sensors, actuators and logic to replace on every chamber.

What chilled water does an Agrify VFU need?

Every Agrify vertical farming unit cools through a water chilled fan coil, so the building needs a chiller plant, pumps and piping sized for the total number of chambers. A chamber on a warehouse floor with no chilled water loop has no cooling, which makes the mechanical plant a bigger line item than the chambers themselves.

Ask the seller for the original mechanical drawings, which should show supply temperature, flow per chamber and the chiller tonnage the facility ran. Without them, plan on an engineer reverse engineering the load from the lighting and chamber count.

  • Fan coils: pressure test each coil and check for corrosion at the connections.
  • Condensate: confirm every chamber has a working drain path. The fan coil dehumidifies, so it makes water.
  • Valves and controls: identify the chilled water valve on each chamber and how it is commanded. If Insights drove it, it ties back to the software question.
  • Plant: if the chiller is not part of the sale, size a new one before you buy.

Our cannabis HVAC design guide covers chiller and loop sizing, and the facility design team can lay out a VFU building's mechanical room alongside the chamber grid.

Will your building fit stacked VFUs?

Your building fits stacked VFUs only if clear height covers the number of tiers you plan plus access, and the floor can carry the loaded stack. Agrify's 2021 report gives an 8 foot working area per chamber and stacking up to 3 units tall, but it does not publish chamber weight or overall height.

Measure a chamber yourself before you plan a layout. Then have a structural engineer check slab and mezzanine loads with irrigated media in the trays, because a wet chamber weighs much more than the one on the truck.

Agrify's 2021 model put 253 VFUs in a 20,000 square foot building to match the 16,200 square feet of canopy in a 45,000 square foot conventional facility. The same report estimated build out at about $27.7 million for a 45,000 square foot VFU facility, and said its smallest commercial deployment to that point was 63 VFUs. Treat those as Agrify's own planning figures, not measured results.

How do you check VFU lighting, curtains and electronics?

Check VFU lighting, curtains and electronics chamber by chamber with power on, because each one is a separate climate zone and one bad component takes a whole chamber out of production. Look for cracked or clouded polycarbonate lenses, dead LED segments, curtain motors that stall and electronics enclosures that have lost their seals.

  • LEDs: run each fixture at full output and take a PAR reading at canopy height in the same spots on every chamber.
  • Interlighting: raise the curtains and confirm the interlights dim or shut off as designed.
  • Curtains: cycle each motorized curtain fully open and closed on both sides.
  • Sensors: compare each chamber's temperature and humidity readings against a calibrated handheld meter.
  • Enclosures: open each IP65 box and look for moisture, corrosion or missing gaskets.

Write down every failed part with its location and any part number on the component. That list becomes your spares order and your negotiating sheet.

Where do VFU parts come from without factory support?

VFU parts now come from three places: spare chambers you buy for parts, off the shelf components that match what Agrify installed, and fabrication. Agrify sold the line in December 2024, and the sale announcement makes no commitment on parts, so plan as if no parts desk exists.

The best protection is buying more chambers than you will run. If a seller has a full room, buying the extra units as a parts bank is often cheaper than chasing a single motor or driver later. Fans, LED drivers, sensors and valves may have standard replacements. Molded panels, frames and curtain assemblies probably do not. Our Agrify VFU and extraction equipment page tracks which lines still have any outside service.

If the same seller is clearing Agrify era extraction gear too, our extraction equipment guide covers what to test on each system type before you add it to the deal.

Is a used Agrify vertical farming unit worth buying?

A used Agrify vertical farming unit is worth buying when you have written software access, a chilled water plant you already own or can size, and enough chambers to run plus spares. Without those three, the cost of making chambers run can pass the cost of building a conventional room.

A conventional flower room puts lighting, airflow and dehumidification at room level, with parts you can buy from many suppliers. Our grow room design and airflow guide shows that layout, and it is the fair comparison for any VFU offer.

Agrify VFU FAQ

Does anyone still make Agrify vertical farming units?

Not Agrify. The company sold its cultivation business, including the VFU line, the total turnkey assets and Agrify Insights, to CP Acquisitions, LLC on December 31, 2024, and later renamed itself RYTHM, Inc. We have not confirmed whether CP Acquisitions builds new chambers. Treat every VFU on the market as used or surplus.

How much does a VFU yield?

We do not have measured yields from operating sites to publish. Agrify's 2021 annual report claimed about 31 percent higher yield than a conventional LED setup and assumed 35 pounds of product per VFU per year in its production fee model. Those are company figures from a sales period, so ask any seller for their own harvest records.

Can VFUs be moved to a new building?

Yes, but plan the move like an installation, not a delivery. Each chamber needs chilled water, power, condensate drains and control connections, and stacked units need structural review at the new site. Photograph and label every connection before disassembly, and keep curtain and lighting hardware with its own chamber.

Is the Agrify Insights software still available?

Insights went to CP Acquisitions, LLC in the December 2024 sale of Agrify's cultivation business. Agrify's announcement did not address existing customer licenses, so contact CP Acquisitions directly and get any license confirmation in writing, tied to the chamber serial numbers, before you buy.

Tell us how many chambers you want, or how many you have to sell, through the equipment request form. For pricing context on used gear in general, see our answers for used equipment buyers and sellers.

Trevor Christensen
Trevor Christensen

Founder of Urth & Fyre. 1M+ square feet of cannabis facilities designed and optimized. Every answer on this site is his.

About Trevor →
Read next —

More from the blog